listing for S
strsetup.conf - Configuration file for STREAMS drivers
The /etc/strsetup.conf file is the configuration file for STREAMS drivers.
The strsetup.conf file specifies one or more character special files (or
nodes) to be created when a STREAMS driver is configured into the kernel.
If the driver is not configured, no character special files are created for
it. If an old version of the file exists, the strsetup command removes it
before the new one is created.
The /etc/strsetup.conf file is defined as a Context-Dependent Symbolic Link
(CDSL), and must be maintained as such. See the System Administration
manual for more information.
Each entry in the /etc/strsetup.conf file specifies a driver name, device
special file name, file mode and minor number. See the EXAMPLES section
for a sample strsetup.conf file.
Each line in the file is of the form:
driver_name filename file_mode minor_number
The fields have the following meanings:
Specifies the name of the driver as reported by the strsetup -c
command. This field is used to match the names read by the strsetup
command from the kernel and must match exactly (the match is case
Specifies the full path name of the character special file or files to
be created when driver_name is configured into the kernel. The
filename can contain one conversion specifier in the style of
printf(3). This conversion is used to include a minor device number in
the filename. The permitted conversions are the following:
%d Prints the minor number as a signed decimal
%x Prints the minor number as a hexadecimal with lower case letters
%X Prints the minor number hexadecimal with uppercase letters
%o Prints octal
%u Prints the minor number as an unsigned decimal
%i Prints the minor number as a signed decimal
Note that you must use a double percent sign (%%) to include a percent sign
in the filename. Optionally, each of these conversions can include a
specification for some number of leading 0's.
This is done by following the % with a 0 and one or more digits specifying
the total number of digits to be printed. The 0 must appear after the %.
See the printf(3) reference page for more information.
Any directories in the path of the filename that do not exist are created.
Specifies the file mode assigned to the file when it is created. The
file_mode field must always be in octal. The file is always created as
a character special file.
Specifies the minor device number field. The strsetup command reads
the major device numbers from the kernel. This field indicates to the
strsetup command how to assign minor device numbers. This minor_number
field can contain the one of the following values:
Indicates that the device should be created as a clone device. In
this case the major number becomes that of the special clone
pseudo-device driver and the minor device number becomes the
device's major number. Note that the word clone must be lowercase.
N Creates a single device with the minor device number N. Note that
N is a decimal number.
M-N Create M-N nodes with the devices' major numbers and minor numbers
between M and N. Note that M and N are decimal numbers. When a
range of minor numbers is specified, a filename conversion
specifier can be used to make certain that each node created is
The following is a sample /etc/strsetup.conf file:
driver name filename file mode minor number
ptm /dev/ptmx 0666 clone
log /dev/streams/log 0666 clone
nuls /dev/streams/nuls 0666 clone
echo /dev/streams/echo 0666 clone
sad /dev/sad/admin 0666 clone
pts /dev/pts/%d 0666 0-127
STREAMS setup configuration file
Network Programmer's Guide
listing for S